Printable Catalog WMeShop.com

How the revitalizant works:

Results after treatment with the revitalizant

General information about the XADO revitalizant

Treatment procedure for steering wheel booster

Dosage

Note

Package

XADO aerosol for petrol engines of any models of automobiles

• Repairs and protects any modification of petrol engines during regular operation.
• Restores engine power and reduces exhaust emissions.
• Saves fuel.

Major results of the treatment

Main advantages of the treatment

Recommendations

Procedure of repairing a car petrol engine (3 aerosol x 10 ml):

Note!

Dosage

Package

XADO aerosol for small engines

How the XADO aerosol works:

Results after treatment with the revitalizant

General information about the revitalizant

Note

Package:

XADO aerosol for transmission, gear box, diff & transfer case.

Main results of the treatment

The main characteristics of the cermet coating:

Main advantages of the treatment

Recommendations

Procedure of treating

1. Spray an aerosol into the oil filler neck of gear box, transfer case or differential according to the following chart.
2. Revitalizing is considered to be complete after 50 operating hours or 930 miles (1,500 km) run.

Note!

Dosage

Package

Revitalizant XADO for the engine cylinder-piston group

• increased compression in the cylinder;
• restored geometry of the cylinder, elimination of scores;
• protection of rubbing parts against wear during could start-up;
• reduction of noise and vibration;
• increase in engine power;
• fuel savings;
• reduction of CO and CH emissions.

• disassembly and replacement of parts are not required;
• opportunity of selective repair ( reduced compression in one, two etc. cylinders);
• immediate results (during the first 30 minutes the compression in the cylinder increases by 21.34- 28.44 psi (1.5-2.0 kgf/cm²).

Piston rings provide the seal between the piston and the cylinder wall for compression. Rings also prevent oil from invading the combustion chamber. If the loss of engine power is accompanied by an increased consumption of fuel, oil and black exhaust smoke, the most probable cause is low compression from worn piston rings or from damage to the cylinder walls.
Applications: vehicles, bicycles, scooters, outboard motors of boats, gasoline saws, lawn-mowers and other engines with pre- mixed fuel and oil system.

Treatment procedure for the cylinder-piston group of the gasoline engine

1. Warm up the engine to operating temperature.
2. Unscrew the spark plug from the cylinder, disconnect the central wire of ignition distributor and commutator.
3. For two-stroke engines: set the piston at top dead center (in order to avoid gel ingress into inlet and outlet ports).
4. Squeeze out the tube contents into the cylinder.
Note!!! Squeeze out so that the tube contents get onto the cylinder wall and not on the piston.
5. Provide 15 - 20 piston strokes (by a crank handle, towing, turning of driving-wheel, etc.).
6. Replace the spark plug and engage the starter 3-4 times for 3-4 sec. in 15-20 sec. intervals.
7. For two-stroke engines: dissolve the contents of one more tube in 5-10 ml. of motor oil and pour it into the fuel tank.
8. Connect the central wire, commutator, start up the engine and let it idle for no less than 2 minutes.
9. Run as normal.

For hard-to-reach places use a syringe with a plastic tube attached to the end. In this case the contents of a tube should be dissolved in 5-10 ml of motor oil.
Note!!! To avoid hydroblow the total volume of introduced into the cylinder liquid should not exceed 20 ml.
During diagnosis you should pay attention to adjustment and operable condition of valve timing!

Revitalizant gel XADO for diesel engines of any models of automobiles

Main results of repair of car diesel engine by XADO

• rubbing parts are reconditioned and protected against wear;
• restored geometry of the parts;
• fuel savings at idle up to 30%;
• oil pressure increasing;
• equalizing and increasing of compression in the cylinders;
• engine power approaches up to 100%;
• reduction of noise and vibration by 10 times;
• possibility of operation (up to 187 miles (300 km)) after an accidental oil leakage;
• reduction in CO and CH contents in the exhausts by 2-10 times.

• disassembly of engine is not required;
• improvement of engine work as early as in 31-62 miles (50-100 km).

Effectiveness and engine working ability mainly depend not only from the condition of an engine itself, but from many other factors, processes and mechanisms which accompany, participate in and influence its work. For instance, a high consumption of oil could be a result not only of considerable wear of engine parts, but of a nonhermeticy of pads, a wear of glands, sticking of rings in the cylinder. That is why while taking a decision to treat your engine you should first of all draw your attention to both typical signs of the wear and general symptoms. For instance:

• low-pitched dead sound in the lower part of the crank case grows noticeably while the crank-case increases its rotational speed (the wear of main bearings);
• rhythmical sonorous metallic sound rises while the load increases (the wear of conrod bearing);
• engine overheating;
• exhaust silencer smokes;
• loss of power;
• high consumption of fuel;
• decreased pressure and increased oil consumption;
• high vibration and noise.

The treatment of new and normally working engines is considered opportune and effective. Accumulated experience of XADO application is an evidence of as early as possible necessity of prophylactic treatment of such engines. At that new parts become run-in and those with a small wear are quickly reconditioned. Due to an unusually low friction coefficient of a protecting coating being formed internal loads on engine parts decrease, and this fact makes their service life considerably longer. And then if some troubles take place you should look for their causes on "the surface": a carburetor, an ignition system, fuel quality.

XADO dosage is defined by oil system capacity, which in its turn is proportional to the area of friction pairs.

Application for the repair of automotive diesel engine with lubricant capacity of 2 to 10 quarts (2-10 l) (3 tubes).

Note!
DO NOT CHANGE the oil until treatment has been completed!
It is possible to treat at idle: 4 hours are equivalent to a running of 120 miles (200 km).
Treat new engines with one dose: two tubes simultaneously.
Added to Inventory on: Monday 08 March, 2004
Manufacturer: XADO

Price: $27.00 USD

Revitalizant gel XADO for fuel equipment

Major results of the treatment

• restoration of geometry and protection against wear of rubbing parts of HPFP (high-pressure fuel pump) of all types, injectors and unit injectors;
• reliable protection against low-quality fuel;
• reduced fuel consumption;
• reduced noise and vibration levels;
• engine power enhancing;
• reduced emissions of toxic components.

• disassembly is not required;
• universality;
• fast effect.

1. Apply to the fuel, which corresponds to the season.
2. Additional (optional) filtering devices may decrease revitalization efficiency.
3. Protective coating is formed on any functioning mechanism. However, if the mechanism (assembly) condition is critical (100% wear, mechanical break), you should replace destroyed parts.

Treatment procedure

1. Squeeze out the contents of 1 tube into the fuel tank which contains a minimum of fuel.
2. Fill into the tank 42- 63 quarts (40-60 l) of fuel.
3. Run the vehicle as normal.
4. Revitalization is considered complete after 100 hours of mechanism work (approximately 1,865 miles (3,000 km) run).

For treatment of diesel engines of heavy-loaded cars and other diesel engines with big capacity you should apply the gel for fuel equipment according to the Table below.

Note !

1. The characteristic feature of the beginning of revitalization is an improvement of mechanism operation (decreasing of noise, vibration, exhaust opacity) just from the first miles of run.
2. It is recommended to double the dose if the wear is very strong.
3. If after 60 -120 miles (100-200 km) run the mechanism fails to improve its performance then the most probable cause of it is faulty diagnostics.

Note.

• Use the gel with fuel corresponding to the season.
• Additional (not regular) filtering equipment may reduce the effect of revitalization.

Revitalizant gel XADO for gear boxes, transfer cases and differentials

Main results of the treatment

• rubbing parts are reconditioned and protected against wear;
• restored geometry of the parts;
• elimination of pits and scratches on working surfaces;
• reduction of noise and vibration by 10 times;
• possibility of long operation after an accidental oil leakage.

• disassembly is not required;
• universality;
• fast effect.

Although the breakdown of gearbox takes place not very often its repair and disassembly are complicated and expensive. XADO will help and it is still possible to "cure" overheating, difficult gearshift, grinding sounds in the gearbox or the noise of differential but the better way is to do it in advance and not wait for the symptoms of disease.

Procedure of treating

1. Squeeze out the revitalizant into the oil filler neck of gear box, transfer case or differential according to the following chart.
2. Revitalizing is considered to be complete after 50 operating hours or 930 miles (1,500 km) run.

Note!
1. The sure sign of the beginning of revitalization is mechanism noise reduction as early as the first few miles. If noise reduction improvement of mechanism running) stops at any time, this fact points to a heavy wear of the mechanism, so it is necessary to double the ecommended dose.
2. If after 60 - 120 miles (100-200 km) run the mechanism fails to improve its performance, the most probable cause of this is a faulty diagnostics.
3. DO NOT use in automatic transmission!

Revitalizant gel XADO for petrol engines of any models of automobiles

Main results of repair of car petrol engine by XADO

• rubbing parts are reconditioned and protected against wear;
• restored geometry of the parts;
• fuel savings at idle up to 30%;
• oil pressure increasing;
• equalizing and increasing of compression in the cylinders;
• engine power approaches up to 100%;
• reduction of noise and vibration by 10 times;
• possibility of operation (up to 187 miles (300 km)) after an accidental oil leakage;
• reduction in CO and CH contents in the exhausts by 2-10 times.

• disassembly of engine is not required;
• improvement of engine work as early as in 31-62 miles (50-100 km).

Effectiveness and engine working ability mainly depend not only from the condition of an engine itself, but from many other factors, processes and mechanisms which accompany, participate in and influence its work. For instance, a high consumption of oil could be a result not only of considerable wear of engine parts, but of a nonhermeticy of pads, a wear of glands, sticking of rings in the cylinder. That is why while taking a decision to treat your engine you should first of all draw your attention to both typical signs of the wear and general symptoms. For instance:

• low-pitched dead sound in the lower part of the crank case grows noticeably while the crank-case increases its rotational speed (the wear of main bearings);
• rhythmical sonorous metallic sound rises while the load increases (the wear of conrod bearing);
• engine overheating;
• exhaust silencer smokes;
• loss of power;
• high consumption of fuel;
• decreased pressure and increased oil consumption;
• high vibration and noise.

The treatment of new and normally working engines is considered opportune and effective. Accumulated experience of XADO application is an evidence of as early as possible necessity of prophylactic treatment of such engines. At that new parts become run-in and those with a small wear are quickly reconditioned. Due to an unusually low friction coefficient of a protecting coating being formed internal loads on engine parts decrease, and this fact makes their service life considerably longer. And then if some troubles take place you should look for their causes on "the surface": a carburetor, an ignition system, fuel quality.

XADO dosage is defined by oil system capacity, which in its turn is proportional to the area of friction pairs.

Application for the repair of automotive gasoline engine with lubricant capacity of 2 to 10 quarts (2-10 l) (3 tubes).

Note!
DO NOT CHANGE the oil until treatment has been completed!
It is possible to treat at idle: 4 hours are equivalent to a running of 120 miles (200 km).
Treat new engines with one dose: two tubes simultaneously.

Buy XADO revitalizant gel for petrol engines (tube, 9 ml) at XADO online store. You can see lowest price on XADO revitalizant gel for gasoline engines (tube, 9 ml). This product’s being sale online. Buy XADO tube now, buy XADO online it is safe & fast.
Added to Inventory on: Monday 08 March, 2004
Manufacturer: XADO

Price: $21.00 USD

Revitalizant gel XADO for Hydraulic Steering Wheel Booster

How the revitalizant works:
During revitalization of the hydraulic system a cermet layer, grown on the crystal lattice of the metal surface layer, is formed on the friction pair surfaces. So, the conventional metal to metal contact is replaced by a practically non-wearing cermet to cermet contact.

General information about the revitalizant
XADO revitalizant is compatible with all types of automobile hydraulic fluids: ATF (Dexron®, Mercon®), CHF, LHM, Power Steering Fluid etc.), does not have chemical reaction with them and does not change their viscosity and other physical-chemical characteristics.
XADO revitalizant is compatible with any additives to hydraulic fluids, no matter in what sequence they are applied.
The protective cermet coating is formed on any working mechanism, however, if the state of the mechanism (part) is critical (100% wear-out), the ruptured parts should be replaced.

Treatment procedure for steering wheel booster
Having once treated a steering pump which repair is not simpliest and cheapest you can for a long time forget the troubles concerning its breakdown and search of spare parts.

1. Revitalizant should be put into steering pump reservoir
2. At that point you should check the oil operating level.
3. After adding the revitalizant, rotate the steering wheel from stop to stop for 5 to 10 minutes.
4. Revitalization is considered to be complete after 50 hrs of mechanism operation (932 miles (~1,500 km) run).

Note!
1. A sure sign of revitalizing beginning is improvement in the operation of steering device (steering wheel force augmentation, operation accuracy, reduction of noise) as early as the first miles of run.
2. If after 60 -120 miles (100-200 km) run the mechanism fails to improve its performance then the most probable cause of it is faulty diagnostics.
Added to Inventory on: Tuesday 09 March, 2004
Manufacturer: XADO

Price: $21.00 USD

XADO gel-revitalizant for barrels of rifled arms

Technical info

Step 1 (10 shots):
• Use a rifle brush to apply red gel to the inner barrel surface.
• Apply the gel to the bullet surface protruding out of the cartridge.
• Fire once.
• Repeat items 1 and 2 and fire again no less than nine times.

Step 2 (10 shots):
• Treat the barrel bore and the bullet with the yellow gel and fire no less than ten times.

Step 3 (10 shots):
• Apply green gel and fire no less than ten times.

Features

Benefits

Metal conditioner XADO HighWay.

• modify surface friction (due to effect of revitalization);
• improve the lubricating properties of oil.

• complex (two-part) of the metal conditioner plus atomic revitalizant.

Advantages

Application instructions

Note

RF * 5,5 means that the engine is protected from this deterioration.
RF (Revitalization Factor) - indicator of the effectiveness of rehabilitation and protection against wear. Max - 100,0.

Package: